Search Mailing List Archives
[openflow-discuss] connect my pronto switch to openflow contrller
dan.talayco at bigswitch.com
Wed Mar 21 22:44:07 PDT 2012
The datapath ID is a unique id for the switch. It is normally based on the MAC address but may be any 64-bit value.
The log level determines how much debug output is sent to the log files. It is one of error, warn, verbose….
On Wednesday, March 21, 2012 at 3:20 PM, Weiyang Mo wrote:
> Thanks very much for your advice about installing Pronto.
> Now I come to the final steps but get some problems. I log in to switch configuration panel via broswer. But I have no ideas about how to set OpenFlow Controller IP address and Datapath ID of the switch.
> I use OpenFlow tutorial(includes Openflow, NOX, Mininet, Flowvisor,etc) loaded by Virtual Box. Is the controller IP address 192.168.56.102(eth3,host-only network) which is also used as SSH access into OpenFlow?
> Now I set following parameters:
> ip address for the switch: 192.168.1.1
> Netmask for the IP:255.255.255.0
> Gateway IP address for the switch:192.168.56.1
> System Name:pronto
> OpenFlow Controller IP address:192.168.56.102
> OpenFlow Controller TCP port:6633
> Fail open/close: open
> Datapath ID of this switch: ?
> Log level:?
> What Datapath ID should I set? What Log level means? and what Fail open/close means?
> Thanks very much.
> Weiyang Mo
> openflow-discuss mailing list
> openflow-discuss at lists.stanford.edu (mailto:openflow-discuss at lists.stanford.edu)
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the openflow-discuss